ReadyLIFT TeraFlex Dana 60 Ball Joint Kit Set of 4 92-22 Ford F-250/F-350 & 94-99 Ram 2500/3500

If you run larger tires, tow heavy loads, drive rough roads, or spend time off-road, your factory ball joints can wear out surprisingly fast. When that happens, you may notice loose steering, uneven tire wear, wandering on the highway, clunking noises, or a front end that just does not feel as tight and controlled as it used to. The ReadyLIFT TeraFlex Dana 60 Ball Joint Kit is designed to solve those problems with a much stronger and more serviceable setup built specifically for heavy-duty Dana 60 front axles found in Ford Super Duty and select Ram trucks. Unlike factory-style ball joints that are often replaced once they wear out, these heavy-duty joints feature a threaded retaining ring design that allows preload and wear adjustment directly on the vehicle using basic hand tools. That means you can tighten and maintain the joints over time instead of dealing with repeated replacements and costly rebuilds. Each joint uses massive 32mm heat-treated 4140 chromoly steel ball studs, heat-treated steel housings, hardened tool steel wear plates, and heavy-duty snap rings to better handle oversized tires, lift kits, offset wheels, towing, and hard off-road use. Dual helical grease grooves help improve lubrication while the low-profile dust seal helps keep dirt and debris out for longer service life. This complete upper and lower set of four ball joints is built to deliver tighter steering feel, improved durability, and more confidence behind the wheel whether your truck is used for daily driving, hauling, towing, or trail use. Grease zerks remain accessible even with axle shafts installed, and the included retaining ring adjustment tool makes future servicing easier. For truck owners tired of premature ball joint wear and sloppy steering, this kit provides a stronger long-term solution designed for real-world abuse.