Quick Ship SKU #: NEM-161410-main Nemesis Industries Outback Rear Bumper 19-23 Jeep Gladiator JT

If you are looking for a bumper that breaks the mold then look no further than the Outback rear bumper for the Jeep Gladiator. We pushed away from our traditional styling to design a bumper that flows with the rounded corners of the Gladiator bed giving the bumper a timeless styling unlike anything else on the market. The slim profile and aluminum construction adds additional clearance while decreasing weight over the factory bumper and helps create a streamlined appearance that definitely stands out from the rest.

The Outback bumper is designed to work seamlessly with the factory hitch, sensors, tow hooks, and license plate lights preserving the full functionality of your vehicle without any compromises. The license plate lights are set flush with the face of the bumper to keep them out of harm's way and the sensors plug directly into the new mounts. If you do not have sensors caps are provided to cover the sensor holes. Maintaining the factory tow hooks was a key design element in the development of this bumper. For customers with a single tow hook a second one is available on our site for purchase. The pocket that the tow hook sits in is kept tight to help keep tow straps from sliding during use.

REAR BUMPER WITH SLIDES

For those looking for even more protection a bed slider has been designed that perfectly compliments the rounded corners of the bumper. The slider is constructed of .1875” and .250” A-36 steel and 1.75” x .120 wall DOM tubing giving this slider uncompromised strength. In order to ensure the slider has the foundation to stand up to the rigors of extreme trail abuse we also built an entirely new mount that ties the slider to the frame. The frame mount uses all the factory holes for installation so no drilling is required. To help fine tune the install of the slider left enough adjustability in the mount and slider to allow for tailored alignment to the bumper.

The support system on the back of the bumper has built in zip tie locations and holes for the factory fir trees to be reused and all the sensor locations work with the factory harness lengths eliminating any re-wiring. There is one piece of sheet metal on the hitch cover that does have to be trimmed however that can be handled with a cut off wheel or saw and does not require precise measuring.