Fuel flow is essential for your Cummins to run the way you want it to under high-demand situations. If fuel flow gets too low you can find yourself in fuel starvation mode which puts strain on your injection pump, throttle response falls, and could put you and your pickup into unsafe conditions. Install the Fleece Performance PowerFlo Lift Pump and start feeding your engine again. This in-tank lift pump is the latest in OEM replacement performance and is the only one capable of supporting up to 800hp! Put reliability back into your fuel system, keep strain off your injection pump, increase fuel system longevity, and also better fuel economy by installing this lift pump today.
DIRECT OEM IN-TANK REPLACEMENT:
The PowerFlo Lift Pump retains the factory water-in-fuel sensor, factory fuel heater, and factory fuel lines. All of these are installed in less than half the time of other high flow lift pumps.DUAL GEROTOR:
Two is always better than one, and the PowerFlo delivers two OEM quality gerotor pumps, increasing flow capacity and increased reliability over the factory pump. Capable of supporting up to 800 hp, including dual CP3 pump configurations.SEAMLESS INTEGRATION:
The active fill bucket eliminates the need for tank sumps, draw straws, additional air filtration, and the ¼ tank issues typically encountered when seeking a higher flow lift pump to meet your engine’s needs.Replaces OE Part Number 68490266AA
California Air Resource Board D-834-12 Specifications
- SkuFPE-34562
- ManufacturerFleece Performance Engineering
- MPNFPE-34562
WARNING: CANCER AND REPRODUCTIVE HARM www.P65Warnings.ca.gov
SPECIFICATIONS:
- Operating Pressure: 18-20 psi at idle
- For MY 2020 and up; this pump will not work with the factory installed 50-gallon fuel tank option
- Not for use with cab & chassis applications
NO VIDEOS AVAILABLE
Blog Posts
Recommended Products
Recently Viewed
Added To Cart
Fleece Performance PowerFlo Lift Pump In-Tank 11-24 Ram 6.7L Cummins
Quantity: 0
Cart Total$0000.00